So, I was about to start 'glassing' the hull and I laid the fabric over the boat and...it was too small! I have written to Fyne to see what to do next.
I have stopped obsessing, and have ordered the kit from Fyne Boats. My garage is just long enough for the build (I hope), and the garden shed is just big enough to accommodate the completed kayak (I hope). The finished craft should look something like the photo.
All the panels wired together and ends of the sheer camps glued. Mistake 2...I trimmed these before making sure that the beam was the correct 33 inches, so had to make a couple of small wedges to infill. I also had to take the table off my bandsaw to make enough room... I had some fun with time lapse on my phone too...
I made the decision to include a deck hatch, and cutting it out was a bit daunting! In the end, I made an oval template in some plywood and used a router with a narrow bit - this way I was able to use the cutout as the hatch cover. I made the magnetic closure in the same was as this Laughing Loon video. Here is the internal rim (made from heat-bent walnut) being fitted.
Comments
Post a Comment