Off to Paddle and a Pint

 

Tested out the new seat position on the canal at Tring. It worked really well!

Comments

Post a Comment

Popular posts from this blog

All wired up

Image
 All the panels wired together and ends of the sheer camps glued. Mistake 2...I trimmed these before making sure that the beam was the correct 33 inches, so had to make a couple of small wedges to infill. I also had to take the table off my bandsaw to make enough room... I had some fun with time lapse on my phone too...
Read more

Kit Ordered

Image
  I have stopped obsessing, and have ordered the kit from Fyne Boats. My garage is just long enough for the build (I hope), and the garden shed is just big enough to accommodate the completed kayak (I hope).  The finished craft should look something like the photo.
Read more

The third coat

Image
 Here is the third coat of epoxy going onto the hull. The glass weave has disappeared from the flat bottom, but there is still a little visible on the sides - I might need a forth coat there. I am using a small foam paint roller, and the epoxy goes on very thinly - a good thing, I think.
Read more