Some final details


 The third (last!?) coat of varnish is dry and I am now doing some of the final bits and pieces. I have made the carry handles for the front and back and fitted the foot rests. I have fitted the back support and also epoxied on a couple of small walnut blocks to hold the deck hatch safety line.

It should be ready to launch now, but I will still need to make and fit some foam knee pads and maybe thigh and hip supports. It will also need a spray deck and a paddle!

I also plan to add an elastic net in front of the coaming (for water bottles etc.) but I will do this a little later.

Comments

Post a Comment

Popular posts from this blog

All wired up

Image
 All the panels wired together and ends of the sheer camps glued. Mistake 2...I trimmed these before making sure that the beam was the correct 33 inches, so had to make a couple of small wedges to infill. I also had to take the table off my bandsaw to make enough room... I had some fun with time lapse on my phone too...
Read more

Kit Ordered

Image
  I have stopped obsessing, and have ordered the kit from Fyne Boats. My garage is just long enough for the build (I hope), and the garden shed is just big enough to accommodate the completed kayak (I hope).  The finished craft should look something like the photo.
Read more

The third coat

Image
 Here is the third coat of epoxy going onto the hull. The glass weave has disappeared from the flat bottom, but there is still a little visible on the sides - I might need a forth coat there. I am using a small foam paint roller, and the epoxy goes on very thinly - a good thing, I think.
Read more