Scarfing

 

The 'bilge' and 'sheer' panels are now done and I am now joining together the sections of 'sheer clamps'. I will run out of space to make these at their full length, so will need trim them down a little just to be able to join them in the garage. Once done, they will be glued to the the 'sheer panels'.

Given the tight space and the fact that it takes 24 hours for the epoxy to cure, it is proceeding only slowly (which is a bit frustrating). Hopefully once the boat is wired together I can push on slightly faster...

Comments

Post a Comment

Popular posts from this blog

All wired up

Image
 All the panels wired together and ends of the sheer camps glued. Mistake 2...I trimmed these before making sure that the beam was the correct 33 inches, so had to make a couple of small wedges to infill. I also had to take the table off my bandsaw to make enough room... I had some fun with time lapse on my phone too...
Read more

Kit Ordered

Image
  I have stopped obsessing, and have ordered the kit from Fyne Boats. My garage is just long enough for the build (I hope), and the garden shed is just big enough to accommodate the completed kayak (I hope).  The finished craft should look something like the photo.
Read more

A small change of plan

Image
  I was just starting to fit the deck when it occurred to me to count the nails provided. The number in the bag was fewer than I'll need, so I have contacted Fyne and they will be sending more. In the meantime, I decided to paint the inside of the forward and aft compartments. In other developments,  I have booked to go on a 5 day sea kayak course in Scotland in Spring next year...very excited!
Read more