Bottom's up

 

Here is the boat flipped over and the seams between the panels filled with epoxy filler. Once it's cured I will need to sand the whole hull smooth and round over the edges ready for the glass cloth.

Comments

Post a Comment

Popular posts from this blog

All wired up

Image
 All the panels wired together and ends of the sheer camps glued. Mistake 2...I trimmed these before making sure that the beam was the correct 33 inches, so had to make a couple of small wedges to infill. I also had to take the table off my bandsaw to make enough room... I had some fun with time lapse on my phone too...
Read more

A small change of plan

Image
  I was just starting to fit the deck when it occurred to me to count the nails provided. The number in the bag was fewer than I'll need, so I have contacted Fyne and they will be sending more. In the meantime, I decided to paint the inside of the forward and aft compartments. In other developments,  I have booked to go on a 5 day sea kayak course in Scotland in Spring next year...very excited!
Read more

The third coat

Image
 Here is the third coat of epoxy going onto the hull. The glass weave has disappeared from the flat bottom, but there is still a little visible on the sides - I might need a forth coat there. I am using a small foam paint roller, and the epoxy goes on very thinly - a good thing, I think.
Read more