Not Impressed

 

I am just making the two seats at the moment. I nearly ended up in a pickle when I realised that the seat slats provided in the kit were not all the same length. The shortest was about 4mm shorter than the longest. Not much, you might think, but it was a bit disappointing to find this in a kit of pre-cut components. I had to mark and trim 26 of them.  After that that the seat assembly went quite smoothly. 

Comments

Post a Comment

Popular posts from this blog

All wired up

Image
 All the panels wired together and ends of the sheer camps glued. Mistake 2...I trimmed these before making sure that the beam was the correct 33 inches, so had to make a couple of small wedges to infill. I also had to take the table off my bandsaw to make enough room... I had some fun with time lapse on my phone too...
Read more

Kit Ordered

Image
  I have stopped obsessing, and have ordered the kit from Fyne Boats. My garage is just long enough for the build (I hope), and the garden shed is just big enough to accommodate the completed kayak (I hope).  The finished craft should look something like the photo.
Read more

A small change of plan

Image
  I was just starting to fit the deck when it occurred to me to count the nails provided. The number in the bag was fewer than I'll need, so I have contacted Fyne and they will be sending more. In the meantime, I decided to paint the inside of the forward and aft compartments. In other developments,  I have booked to go on a 5 day sea kayak course in Scotland in Spring next year...very excited!
Read more