Adventures in a Mill Creek 16.5

I have now got five strips on each, side done, together with the center strip. The photo shows the view towards the stern of the kayak. I am quite pleased with the look of the darker walnut strips. I am planning on doing the cockpit coaming in the same walnut. Unfortunately, those walnut strips did for my thicknesser - the head jammed and it melted through the drive belt! A new belt is on order as I think that I am going to have to make some additional strips. Melted drive belt!

  I have now fitted the first deck strip. This was quite tricky as the strip twists through 90 degrees between the stern and bow, so matching it neatly to the hull was impossible (for me). Instead, I left a gap where the wood twists, and I will fill it with a filler piece once the deck is complete. I am putting in a contrasting strip of walnut, so I milled up ten strips from a piece I have had lying around the garage for years. These are about 1m long, so I will need to scarf together four pieces for each side.

  My ceiling sling seems to work, and after scraping and a preliminary sand of the hull, I lifted it and flipped it over. This also gave me a chance to sweep up the floor! I will now be able to start on the deck, although I will definitely need some more strips.

  I have finished 'stripping' the hull. I did use the router as planned, on the first side, but ended up using a pull saw for the other side to make the gap for the final, middle strip. There was a lot of faffing about, mending broken strips, repairing holes, etc. Once the wood was glued in I planed everything flat(ish) with a violin makers plane, block plane and cabinet scraper. Then I filled any remaining cracks, tear-outs, knots, nail holes and screw holes with epoxy mixed with sawdust and some cab-o-sil (to lighten the colour). The next jobs are the outer stern and bow posts (in walnut) and fitting a sling to the garage ceiling so I can lift it up out of the way when I need to.